Related Categories: Precision Angle Block | Sine Plate | Sine Bar | Grinding Fixtures | Drill Press | Adjustable Angle | Adjustable Angle Plate | Collet Indexer | V-block | V Block
View: Grid | List
Hardened and ground steel. Precisely ground angles for setups in tooling, production and inspection. Holes for easy mounting.
item # 2127-0025
Minute angle step 0.2 is built into gage block roll, eliminating step in base plate. Two hardened and ground side rails and one locking strap included. Strap always remains below top surface. Large hinge pins for extra strength. Notes on Order No. 1701-0025: This item's weight exceeds the UPS…
$530.10 - $1561.70
Simple, quick angle setups. Eliminate calculations and avoid errors. Lightly magnetized for better holding. Manufactured from oil hardened, precision ground steel.
item # 1291-0080
…vertical V-block mounting and 72-position index plate for hard index every 5 degrees. Two heavy duty 4-inch diameter tapered roller bearings in spindle. Extra large V-block capacity and built-in sine bar for setting angles between hard index locations. Sine set compatibleInclides fitted wooden case.
item # 1701-0923
Fast, simple and easy to use for drilling, milling and setup applications. Adjustable 0 to 60 degrees by locking bottom hex screw. Hardened to Rc 50-55.
item # 2127-0020
…accurate and direct means for setting or checking angles. Eliminates calculations to help avoid errors. Blocks in 1-degree increments to 5 degrees; then 5-degree increments to 30 degrees. By adding the optional 1/4 and 1/2-degree blocks, nearly any angle can be set in 1/4ï¿½ increments. Precision…
$33.10 - $296.85
No sine vise, sine plate, angle vise, angle chart or block gage needed. Consists of 10-, 15- and 30-degree V-blocks; 1-, 2-, 3-, 4- and 5-inch angle plates; and fitted case. Hardened to Rc 45-50, with all ground finish.
item # 1291-0082
* Chrome steel, hardened and ground* Accurate enough for layout and surface plate use* Square, parallel and concentric within ±.0001 inch * Models 475-015 and 475-020 can be set up on side or bottom angles* 90-degree V-angles
$22.00 - $79.00
More versatile than other V-blocks. Can be used on either side, end and base. Ground and hardened for parallelism and squareness. Threaded holes on each side and base attach to angle plates.
item # 1290-0065
…dividing plates* One adjustable tailstock* Crank handle* One each sector and sector spring* Four T-slot bolts and flange nuts* One pair step blocks* One pair serrated end clamps Note: This item's weight exceeds the UPS shipping standard; therefore there will be UPS surcharges added to the estimate…
item # 1990-0005
…table, run the bit down (with motor off) to hold it centered on the bit, then bolt it to the table. Clamping tube is not necessary, since the angled flats kept it centered. Holes automatically will be centered on tube, with no center punching required. If tubing is too large to drill in a single…
item # 1290-0200
…over two pins or inserting gage block* Easily determine inside or outside radius by sliding dowel pin to right for concave and left for convex* Four x 90° graduation in full 360° circle and 6-minute vernier reading* One push/pull knob for radius and angle control and safer, faster operations
item # 2800-0300
Showing item 1 - 12 of 17 items found
|Site Search by|